Search Results for ‘conductor plate’

My 1998 Mercedes e320 is going in limp mode and throwing the code for a conductor plate only 98k on it I could do it my self but I’d need the tools for it or pay the stealer ship but they don’t really care for my old car over the phone it’s almost impossible for a answer and every shop won’t...

Hey 202'ers. I'm going to try and make this post as straightforward as possible and attempt to stay on subject with what's going on. I've read alot of forums related to my issue and have thoroughly followed them but have yet to find a solution. Apologies for the vague introduction, let's...

Howdy everyone! I am preparing for ATF change on my 100k miles ML500. I have a WIX filter and gasket and I'm wondering about the ATF. I was considering either AMSOIL, or Fuchs Titan ATF 3353. Which ATF do you all prefer? I also have a question concerning this service. Why does one "NOT"...

Hey all, working on a 2006 C350 with transmission issues. Got the car for a song and as a project (retired people get bored 😉). Anywho, I'm used to working on the 722.6 and NAG1 trannies, which are heaven compared to these 722.9. I understand that the parts interchange is over 50% between them...

Item is in good working condition. Conductor plate will come Pre Program to your VIN. Once installed it will need to be activated on your car. Link to Purchase Models: X164 W164 W251 R230 R171 R172 X204 W218, W203 W204 W209 W211 W212 W215 W216 W219 W220 W221, 2014 2015 14 15, 03 04 05...

Van is in Limp Mode, 35 mph tops, no shifting once out of park. TCM has been fouled by trans oil, which wicked through the wire harness, from the trans valve body up into the passenger compartment. So far, cleaned out the connectors at both ends of the trans harness and replaced connector...

I've been having problems with my GL going into limp mode occasionally and setting various transmission codes, including input shaft speed sensor faults. I purchased a pair of speed sensors and did a poor job of installing them into my conductor plate. The vehicle immediately set more speed...

I am trying to figure out the following to see if its worth fixing. The car is in great condition otherwise: VIN wdbuf56x97b164667 Diagnostic: ME/ECM code 1745/P2716: Transmission module fault. Scanned EGS/TCM, Code 2716: Internal electric check of Y3/8y4 clutch solenoid valve failed Question...

Hey guys been having issues with my transmission (722.6). So my trans has been not wanting to shift from no specific gear just randomly or shifting super aggressive lately. Also have Engine Electronics CEL, Read codes and I'm getting (Transmission Control Module mil request) and (Incorrect Gear...

I have my fathers s55 w220 tuned with new pulleys has transmission problems per usual, we had a TCM installed and coded at a specialty shop; problems prior to installation of part was " not shifting past 2nd-3rd gear" as my father put it. After part was installed the tech that coded vehicle...

I have a 2007 E320 Blutec with the 722.9 transmission. About 80,000 miles ago I had the conductor plate (also known as electro-hydraulic control unit) rebuilt for a faulty Y3/8n1. It worked great for about 80,000 miles--which was certainly the neighborhood of the miles I got out of the original...

I have a Mercedes Benz W203 C270 2001, 5speed Automatic it Doesn't Shift i have tried everything from one Transmission oil to another. I have even used the Oil that was recommended by Mercedes Benz Dealer but there is no any change i tried changing the Transmission Filter and Conductor plate bu...

I have a 2001 c240 260,000 kms and it has been nothing but trouble as I had the c230k before this and had nothing but good to say but any way, My current issues is the c240 is stuck in limp, I have replaced valve body with one from a c230k with no transmission issues and same problem arose...

Mercedes w203 c230 2006. Car Randomly won’t rev past 2500, no check engine light. Restart fixes problem. Error code p2767. Also code p2004 has been confirmed. Are these linked? Car has been working fine on and off, sometimes all good for a few months then problem reappears. OBDII tells me tests...

Hello I’m new here and was looking for some recent news on finding and installing a conductor plate for my 2007 C230. I believe the transmission is a 722.9 7GTRONIC I’ve seen a lot of people from other pages talking about it and the symptoms from everyone’s experiences are exactly the same as to...

Hello, I'm new here so excuse me if i missed any step before adding this subject. My car is C250 2012 4 Cyl not AMG with 65k KM. 2 weeks ago i was driving then at a time pressed the gas pedal for kick-down and surprised with little delay to interact with shaking for 2 seconds then it goes...

Hey guys, I recently bought a nice clean C280 4matic. It has 140,000Km. Recently the transmission started acting up. Occasional hard shift, occasional no shift until key turned off and restart. Then last week it did a very hard shift from 1 to second and then wouldn't shift anymore. Check...