Mercedes-Benz Forum banner

Setup dimensions.

2K views 7 replies 2 participants last post by  Dr. Sternschnuppe 
#1 ·
For the 717.000 5-spd transmission as shown in attached. Attached file is a .400. need the same dimensions for the .000
Should be in the W116 Haynes manual. Many thanks.
 

Attachments

See less See more
1
#6 ·
Should be more specific. Dimension "C" on my tranny is 150mm. If you set the arm to 95mm
the shift rod is an inch short. EPC says the G76/27-5 was the only unit used in the 280SL, my
info from Germany is that the .000, the 2 piece, with seperate bell, cast iron cased 5 spd was used until 1975 when
the 5-spd option was dropped. They brought the option back in 1983 but with the .400, one piece aluminum
series. I only asked about the 107042 not up on any other models. Any other info you have would be appreciated.
Enclosed is the photo they sent me, .000 on the left .400 on the right.
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top