Mercedes-Benz Forum - View Single Post - 35mm lowering springs and shims ???
View Single Post
post #19 of (permalink) Old 04-28-2019, 12:14 PM
Snipersking
BenzWorld Member
 
Snipersking's Avatar
 
Date registered: Sep 2011
Vehicle: W140 1998 S320
Location: Iraq
Posts: 297
Mentioned: 0 Post(s)
Quoted: 31 Post(s)
Quote:
Originally Posted by jal1224 View Post
Inspect the lower front wishbone inner bushings, front and rear. If they appear to be off center, bulging, or lopsided, replace them. The rear ones are fluid filled, and can rupture if old, or improperly installed. Both front and rear bushings must also be installed in the control arms with a particular orientation. New replacement arms have been known to have the bushings improperly oriented. There are instructions in the DIY section.

Disconnect the upper control arm from the spindle. You should be able to move it up and down by hand against the resistance of the bushings. If it or the upper ball joints are frozen, replace the arms. If the upper ball joints are split, but the joints are still good, you can replace just the boots with ones from a Porsche 928. Do a search here for a pictorial on how to do it. While the upper control arm is disconnected, make sure you can move the spindle assembly pivoting on the lower ball joint. If the lower ball joint is frozen or extremely difficult to move fore and aft or in and out, replace it.

Make sure the sway bar body mount bushings are good. They should be considered a wear item and periodically replaced. They can wear so badly as to create metal to metal contact.


Bro believe it or not all the components you have mentioned were replaced but I think the mechanic did something wrong [emoji20]


Sent from my iPad using Tapatalk


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Snipersking is offline  
 
 

Title goes here

close
video goes here
description goes here. Read Full Story
For the best viewing experience please update your browser to Google Chrome