hey everyone! I'm selling my project car for $2,900 USD. I'm located in Northern California, near San Francisco. the car is a 190E-2.3 8 valve and has a 5 spd manual transmission. it has a brand new/fully built engine with ZERO miles and a brand new clutch. it doesnt run good due the old fuel system from my other old 190E-2.3. anywayz, I'm trying to sell the car AS IS.
engine specs:
-fully built block and head by KBR performance tunig / TEM machine shop.
-96.5mm oversized KS pistons
-shot peened rods
-polished crankshaft
-Hasting piston rings, Federal Mogul main & rod bearings
-fully Balanced & Blueprinted pistons,rods,caps,crankshaft,main pulley & flywheel
-8 valve head with new valve seals, 3 angle valve job, polished head & "squared" surface.
-new timing chain, oil pump, cam gear, crank gear, oil pan, and engine gaskets.
-RAM stage 1 clutch
any more questions regarding the car, please Email me at KBRperformance@hotmail.com
thank you.
-Karlo Belarmino / KBR performance tuning
engine specs:
-fully built block and head by KBR performance tunig / TEM machine shop.
-96.5mm oversized KS pistons
-shot peened rods
-polished crankshaft
-Hasting piston rings, Federal Mogul main & rod bearings
-fully Balanced & Blueprinted pistons,rods,caps,crankshaft,main pulley & flywheel
-8 valve head with new valve seals, 3 angle valve job, polished head & "squared" surface.
-new timing chain, oil pump, cam gear, crank gear, oil pan, and engine gaskets.
-RAM stage 1 clutch
any more questions regarding the car, please Email me at KBRperformance@hotmail.com
thank you.
-Karlo Belarmino / KBR performance tuning