Mercedes-Benz Forum banner

PSE Pump - How To Release Connector?

747 views 2 replies 2 participants last post by  LWB250 
#1 ·
I'm feeling challenged tonight, folks.

Can someone please give me some direction on how to release the big connector on the PSE pump without breaking something?

I've done this before, but it's been a while. It seems like you pull out a release on the end, but I'm not sure what to push/pull to release the connector.

Thank you in advance,

Dan
 
#2 ·
Dan,

The release bracket is on the rear end of the connector. It is shaped like a U and is required to be pulled back about a 1/2-3/4 inch then the plug can be lifted up. Be careful that you don't pull the connector away from the release bracket or you will have all the wiring come out from the plug. If this isn't clear I will try and get a photo of my old one.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top