I have a set of four 16" factory 8-hole rims. I'm assuming they're off a mid-90s C or S class. Mostly I'm just posting here to see if there's any interest, I figure $150 per rim or $450 for the set is fair, but it's negotiable. I'm also posting as a question... I'm not very familiar with these, any ideas as to what they'll fit? I'll post some pictures if needed, I just need to clean the dust off 'em.
These are located in Pittsburgh, PA.
#1 - If it were me, I wouldn't take pictures of items for sale unless they were cleaned up, it's really worth the wait for everyone, and it leaves a bad impression of how you maintain your belongings, even if it's only a perception...
#2 - Post the true sizes, look on the back of the wheels, the numbers are cast into the wheel. need three numbers, width, diameter & offset
it should look similar to this... 7J x 16H2 ET37 (ET37 means the offset is 37mm)
The offset and width are important to calculate compatability on other models
The examples you give(mid-90's C or S) isn't exact enough and as a matter of fact, according to published charts, although the wheels from these two cars may look the same , they are actually different sizes.
The wheel size number I wrote above is for a W202 95 - 2000, for a W140 the only size for a 16 inch wheel listed in the chart is 7.5J x 16H2 ET51.
That's a very big difference, so post back what is on the back of your wheels, then there is no mistake... I bet what you find is different than either of these numbers... Once you post the true sizes, everyone will be able to say what they will fit on.
Look at this chart here....
Alloy Wheels Direct Ltd | Fitting Chart Index