Mercedes-Benz Forum banner

ne1 ever remove auto shift lever/shaft?

677 views 2 replies 2 participants last post by  drew04 
#1 ·
i changed my factory automatic shift knob with a nicer momo knob and now the base of the knob is higher than the factory piece. i was wanting to cut about an inch off the height of the metal lever...anyone else ever do this? is it easy to remove the lever in order to cut the piece down when it is out of the car. any diy? thanks!
 
#2 ·
I changed my knob also, and it was higher, so I removed it and made an inside measurement by using a wire, I determined that the knob should not be that high, so I re-installed it and pushed down really hard and it went down more. It is just fine.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top