BenzWorld Junior Member
Date registered: Nov 2013
Vehicle: 1997 E320
Location: New Jersey
Mentioned: 0 Post(s)
Quoted: 0 Post(s)
1997 E320 No Start/ No Crank
Hello I would like help from the members of Benz World. I have a 1997 E320 and it doesn't start. I replaced the starter and ignition switch so far but still no luck. I pulled out some stored codes B1040, B1041 and B1755 I know it could be caused battery but Battery is new. Also I hooked up my matco scan tool and found these:
OK- System Exists, No codes
"F" - System Exists, codes present
"!"- Not detected
Electronic selector module - !
Speed sensitive power steering - !
Electronic Ignition Swtich - !
Vehicle Malfuntion control module - !
Signal Acquistion and actuation module - !
EL Code- No response ignition Swtich
SVMCM- No Response
ABS/ASR.ETS/ESP - OK
HFM/ME2 - OK
ESM - !
could these be pointing towards replacement of ECU?
also whenever its communicating with the Vehicle its non-Can communication is that normal? or CAN is not responding. Any input will be helpful thank you