Date registered: Jul 2013
Vehicle: 2000 ML320
Mentioned: 0 Post(s)
Quoted: 5 Post(s)
Hi, I bought a year 2000 ML320 for the wife a few weeks ago, and its now gone into emergency/limp mode twice. before it does this she says when she goes to take of from an intersection, it loses all power and only advances slowly, till she pulls over and stops, and then restarting will fix it till it finally goes into limp mode...
The local auto trans guy cleared the codes , he said there were a lot, and that fixed it, and I had a transmission service done, but a week later its done the same thing again. I connected up my basic OBD2 scanner, and can see most aspects of the car , but two different cheap software versions say no fault codes , so I'm a bit stumped..... is any specific software better with these cars?
I'm using an ELM 327 and OBD Autodoctor...
Any help appreciated :-)
Last edited by DeanK61; 07-31-2013 at 10:21 PM.