Date registered: Aug 2005
Mentioned: 0 Post(s)
Quoted: 0 Post(s)
RE: ignition problems
after looking at the ignition wiring diagram for a 560, which should be fairly the same as yours, I am starting to suspect a worn out ring gear. how many miles do you have on the car? has the transmission ever been removed or replaced?
I'll try to post the diagram.
here is the legend:B11/2 Coolant temperature sensor
L5 Position sensor (via flexplate segments)
N1/2 Ignition control module
R16/1 Reference input resistor (EZL)
S5/3 High voltage distributor
S29/2 Throttle valve switch
T1 Ignition coil
W3 Ground, front left wheel housing (ignition coil)
W11 Ground, engine (wire connection)
X11 Diagnostic socket/terminal TO
a To CIS-E control unit, socket 5
b To engine idle speed control unit, socket 4
c To CIS-E control unit, socket 21
e To plug connection X 26 on engine, socket 3 (circuit 30)
f To plug connection X 26 on engine, socket 1 (circuit 15)
g Not used - ends in wiring harness
I'm not a bad christian, I'm a good atheist.