My top was just replaced, when I was dropping off the car I put the top up at the top shop, I heard a hiss from the back area (knew what it was- hydraulics blew out for the top) Since I had the car there for the top I had him put the new top on (he manually put it up and down) Called Dennis, and he sent me a great set of directions to remove the hydraulic cylinders, sent them off to Dennis. Used the car and put the top up and down for a couple of days until the cylinders showed up. Placed the cylinders back in the car, filled up the reservoir with fresh fluid and tried to put the top down. The windows and roll bar go down, the back part of the top unlocks and goes up but that's it. I manually put the top down and tried to put the top up with the controls, again the windows and roll bar went down, the cover unlocked and lifted to allow the top to go up but it stopped at this point.
Went through numerous threads and tried to disconnect the battery, re-sync the windows, tried to read the X11/4 with a light but only 16 of 38 sockets have pins. Ten sockets lite and 5 did not.
I think I am close but just missing something, any help would be helpful
Also, the roll bar and top switches lite when the key is set to #2 or on position then go out as they should (top up). But the top switch stays lite and the audible alarm goes off when you start to drive (top down) Thanks
Last edited by lynns : 05-23-2009 at 10:55 AM.
| 
