| The 3 rear tail lights (brake light, signal light, parking light) are very easy to change on either side. All three sockets are joined by one connector and you just pinch the tabs to remove it. The bulbs just turn and release. The license plate lights though you must carefully pry open the panel on the inside of the hatch door, undo the torque head screws on the black trim on the outside (They don't seem to come free from the trim, I just undid them 'till they stopped) and while slightly pulling the chrome/black handle trim push the tabs in on the sides of the connector that runs to the release handle "in" the hatch door through the panel. (I could only do one side at a time and could squeeze my hand in so my finger could release it, and while keeping a little tension on the trim switch hands and do the other side) The thing comes out and their's a small wiring harness that come off and you can work on it. The bulbs come out from the inside, just release the sockets from the rest of the trim and pull the bulbs out. To reinstall; re-do the connection, "click" the trim back in the hole, tighten screws and pop panel back in. The End. It's really not that bad.
Anthony |