Steve, I thought about calling this 2008-2020 projects
but with the pattern my last 2 posts have taken, I'll still be working on it in 2021 and be kicking myself for not calling the post something like "rasoul's projects"
So for those needing to catch up...
october projects november projects
So here's the latest of the ECU install. I mounted it right below the glove box. It's accessible enough to plug into the serial port whenever I need to, and it's tucked in just enough where it can't be seen when sitting down (I couldn't put it in the location that makes the most sense, the passenger footwell, because I have a subwoofer there and didn't want the ECU to get any unnecessary vibrations). I poked the harness through a rubber boot on the factory ECU housing, so I can do all my wiring in the factory location. I'm putting my EDIS in there too. And I've run a copper tube to my Y-pipe to go to my ECU, which has an integrated 4-bar map sensor with barometric correction. I figure the copper tube will be more accurate and withstand higher pressures than the nylon tube I ran to my boost gauge.
