Benzworld.org - Mercedes Benz Discussion Forum - View Single Post - 1988 190E starts for 2-3 seconds then stalls

consumidor · 03-04-2006, 06:43 AM

Just an update:

There were 2 problems which prevented the car from running.

1. The EHA was blocking fuel in the fuel distributor, the cause was dirty contacts on the sensors (crank position, and idle air valve). After cleaning and reconnecting these, the car worked perfectly.

2. Vacuum leaks, I am still patching up a few vacuum leaks, but they will prevent a car from running properly.

Another problem that went mis-diagnosed for months due to a scarcity of information about it. The Vacuum modulator valve on the transmission was bad. The result was transmission fluid being sucked into the motor, fouling the spark plugs and just about everything else in its path.

As a note, if you are seeing plumes of white smoke coming from you tail pipe this is the cause of it. White smoke is distinctly different from steam, so make sure you can distinguish the two. In my case so much tranny fluid was being sucked into the motor that it was dripping out of the tail-pipe.

also, the vacuum modulator valve is not easy to get to, you must drop the transmission to get to it. In my case I cut through the metal body from the inside by the gas pedal to get to it. The reason being, the valve must be adjusted for proper shifting, so it needs to be accesible as you test the vehicle.

The final lesson I learned. Leave the expensive parts on your car alone, repair and replace everything around them before replacing them. 2 fuel distributors was expensive, and there was probably nothing wrong with the original one.

03-04-2006, 06:43 AM	#3 (permalink)
consumidor BenzWorld Junior Member Date registered: Nov 2005 Posts: 7	RE: 1988 190E starts for 2-3 seconds then stalls Just an update: There were 2 problems which prevented the car from running. 1. The EHA was blocking fuel in the fuel distributor, the cause was dirty contacts on the sensors (crank position, and idle air valve). After cleaning and reconnecting these, the car worked perfectly. 2. Vacuum leaks, I am still patching up a few vacuum leaks, but they will prevent a car from running properly. Another problem that went mis-diagnosed for months due to a scarcity of information about it. The Vacuum modulator valve on the transmission was bad. The result was transmission fluid being sucked into the motor, fouling the spark plugs and just about everything else in its path. As a note, if you are seeing plumes of white smoke coming from you tail pipe this is the cause of it. White smoke is distinctly different from steam, so make sure you can distinguish the two. In my case so much tranny fluid was being sucked into the motor that it was dripping out of the tail-pipe. also, the vacuum modulator valve is not easy to get to, you must drop the transmission to get to it. In my case I cut through the metal body from the inside by the gas pedal to get to it. The reason being, the valve must be adjusted for proper shifting, so it needs to be accesible as you test the vehicle. The final lesson I learned. Leave the expensive parts on your car alone, repair and replace everything around them before replacing them. 2 fuel distributors was expensive, and there was probably nothing wrong with the original one.