Quote:
ttaleric - 7/11/2005 9:42 AM
How do i do the reset?
|
Since the forum search is down…
Turn the ignition switch to position 2, but do not start the engine. Locate the fuel sender harness connector along the frame, slightly ahead of the rear driver’s side wheel. Unplug the connector, and then reconnect it. Turn the ignition to position 0, then back to position 2, and you should see your gauge recalibrated. If this does not work, repeat the procedure, but with the harness disconnected, cycle the ignition switch from position 2, back to 0, then back to 2. You will have to reconnect the harness with the ignition in position 2, though.
If this still does not work, you may have a problem with the actual gauge in the instrument cluster. In fact, given that you said the TC’s display of DTE was the same, this may be the case, because it and the fuel gauge both get the same sender reading from the CAN bus, so they should be pretty much in sync.
- RODNEY