mxfrank mxfrank is offline
- Home Page
- This Page
|08:11 AM - jzchen quoted mxfrank in post EPC still free?
I had replaced the one on my...
|10:19 AM - trvp quoted mxfrank in post trouble starting 190d
Crank position sensor irrele...
|10:14 AM - mxfrank quoted JoellyM in post Tranny Swap Question
I have a 1988 190E 2.3 with ...
|06:34 AM - Stretch quoted mxfrank in post How can I tell what Transmission this 190e has?
There are a couple of dozen ...
|04:52 AM - mxfrank quoted bcameron in post Where to Buy Driver Front Fender for 190D?
Hi Tricd04 - Looks like RockA...
|09:13 AM - mxfrank quoted trooper6 in post 1991 2.6 pre resistor for aux fans?
Just replaced mine, but my au...
|09:04 AM - Stretch quoted mxfrank in post 722.4 k2 help
Is the side of the piston wi...
|12:50 PM - mxfrank quoted lomtevas in post Another Missing Coolant House Connection
I disagree. There is nothing ...
|06:06 AM - lomtevas quoted mxfrank in post Another Missing Coolant House Connection
... Allowing overflow to imp...
|09:43 PM - fact150 quoted mxfrank in post Best place for a USB charging port?
I'm not sure what all the va...
|02:37 PM - mxfrank quoted ax456 in post Door Lock Cylinder Guides - aka Door Lock Failure
i was about to post..........
|06:00 PM - Bob338 quoted mxfrank in post I'm considering buying a 1985 190D. What should I look out for?
It will truly be a slug, but...
|03:57 PM - probro529 quoted mxfrank in post 1984 2.2L 190D wont start
You have at least one bad gl...
|01:46 PM - joe_pau quoted mxfrank in post Replacing a Compressor and Receiver Dryer
The hardest part isn't going...
|09:19 AM - mxfrank quoted Nfsjunkie91 in post 190E in the snow
Are those Altimax Arctics, mxfra...
|12:29 AM - Stretch quoted mxfrank in post Any idea on how to remove the wiper cover?
Nah...they started reproduci...
|05:11 PM - mxfrank quoted fact150 in post Any idea on how to remove the wiper cover?
Your lucky to have found tha...
|02:56 PM - mxfrank quoted w123fanman in post Bad Injector knock after O-Ring replacement
Any air leak in the fuel system...
|09:41 AM - iamdigitalman quoted mxfrank in post Bad Injector knock after O-Ring replacement
First off, you need to figur...
|09:05 AM - mxfrank quoted iamdigitalman in post Bad Injector knock after O-Ring replacement
Right, well it was finally warm th...