| RE: So I played around with my closing assist pump this evening.
I have same problem with close assist that I experienced in both 500 and 600 124 series.
Always is behaved to the "2 failures and out" rule, that is by disconnecting fuse 9 in the trunk the system re-set and the door assist worked fine twice then failed.
In my case it is only at one door (on the 500 the passenger on the 600 the driver's door.
If this failure is due to detection of a fault in that particular door channel is this due to a leak on that channel or is it due to "lack of lube" or similar in the actuator. I would welcome any advice
A NU BEE |